Archives for October 2015

Gift Card Holder

   

 


Materials needed:

Card stock cut 5 1/2″ x 4 1/4″

DSP cut 7/8″ X 4 1/8″

SNAIL

Dimensional so

Stamp set of your choice 

Markers

Gold and silver doilies


Instructions:

1. Cut card stock as instructed above and with the 5 1/2″ side at the top score at 2″ and 2 1/4″ and fold score lines. Attach the front of the holder to the back using 4 dimensionals, two on each side.

2. Attach the DSP to the front with SNAIL and then stamp the stamp and saying of your choice and cut out. Attach them to the front or inside with dimensionals

3. Add one or two quarter of the gold or silver doilies to one or two of the corners and you are done.

ENJOY!

Share this:

Weekly deals at Stampin’ Up!

Check them out

  

Share this:

Now is a great time to stock up on stamps

Check this out at www.bjstampingtreasures.stampinup.net

  

Share this:

Do you love paper crafts and crafts in general, or do you have lots of gifts to buy for Christmas?

Then join my for a holiday craft fair at our local church. I will be there Oct. 24th 2015 from 9 to 2 pm.

  

Share this:

Weekly deals at Stampin’ Up!

  

Share this:

Straw Holder

  

Materials needed:

Chip board 12″ X 12″

DSP four cut 7 1/2″ x 2″ and two cut 2″ X 2″

Score board

Trimmer

Scissors

1/2″ punch

SNAIL

Embellishment

Tear n tape or sticky strip

Velcro
Instructions:

1. Cut chip board 12″ X 9 1/2″ and then with the 12″ side at the top of the score board, score at 2 1/4 on each side. Turn and score at 2 1/4″, 4 1/2″, 6 3/4″, and 9″. Fold all score lines.

2. Add the pieces of DSP to the outside of the box and assemble the box using tear n tape or sticky strip. Adhere the 1/2″ strip to the opposite side of the box and then adhere the bottom together.

3. Fill your box with straws and then cut off two of the flaps that are opposite each other. With the other two punch a 1/2″ circle in both sides being sure to line up the holes. Close up using Velcro and add an embellishment to the top.

Your stats should shake right out if the holes are lined up right. This way your straws will stay clean.

ENJOY!

Share this:

Square Pillow Box

   
 

Materials needed:

Square pillow box die

Big shot

Tear n tape

SNAIL

One sheet of card stock 8 1/2″ x 11 any color

Other pieces of card stock or DSP

Ribbon
Instructions: 

1. Cut out two square pillow box dies with the big shot and fold on all score lines. Now put tear n tape on the two flaps and adhere together the box.

2. Now fold in the 2 flaps on each side, you can open them later to add your treat or small present.

3. Decorate with ribbon and some of the smaller dies that come with the set.i taped ribbon around one and attend die cut pieces to both.

Enjoy!

Share this: